MASK & PEEL

Shields booth surface from overspray and makes cleanup fast and easy. Bright white for maximum booth visibility. Peelable coating for no-mess cleanup. Applies easily, dries rapidly.

PREPARATION: Carefully read all cautions and instructions before use. Protect hands with solvent resistant gloves, and eyes with safety glasses. Clean dirt, grease and overspray from surface of spray booth and mask grooves with three inch masking tape. NOTE: Coating may not be easy to remove if any overspray remains on the surface of the booth when Mask & Peel is applied. Make sure the booth is free of any overspray before the application of this product. For booths which have been repainted, test a small area to determine if Mask & Peel can be easily removed. Mask & Peel may adhere to some paints. APPLICATION: For best results, use a pressure cup or airless sprayer. A brush or roller may also be used. Apply a generous coat of Mask & Peel that should measure between 8 and 10 mils thick. A heavier coat should be applied to the areas requiring a greater tear resistance. Allow 30 to 40 minutes drying time before using spray booth. Wash application equipment with soap and water immediately after applying Mask & Peel. REMOVAL: Do not use chemicals to remove coating. Beginning along one edge, use a sharp instrument to lift the Mask & Peel coating enough to grasp with your fingertips. Keeping your finger near the booth surface, pull the coating off in large sheets. After removal, used Mask & Peel should be disposed of in accordance with the local, state and federal laws applicable to the disposal of dry paint. NOTE: Keep from freezing. Do not apply Mask and Peel in temperatures below 50°F. Do not apply to porous surfaces, lights or heat lamps.

Part #: KS.MP-229

Price and Units

Units: 5GAL