MAGNETIC BLEND PREP RULER
Standard Work – Blend Ruler
application for use during disassembly in the
Damage Analysis Process to measure and determine the area required for
blending in order to achieve an acceptable color-match.
- Place the edge of the
Blend Ruler labeled “Deformation Ends” at the outer edge of the dent.
- The next label past
Deformation Ends is “Body Work & Sanding”. This area is about where the
outer edge of the sanding process using grades 80, 180 and final featheredge
with grade 220 ends.
- The next label past
Body Work Sanding is “Primer Preparation Sanding”. This area is where the
primer sanding procedure will prepare the substrate for the application of 2
Part Primer. Primer will be sprayed out beyond this area.
-
The next label past Primer Preparation
Sanding is “Basecoat Color Sanding”. This area is where the color sanding
procedure will prepare the substrate for the application of basecoat color.
Color will be sprayed out beyond this area.
-
Mark the adjacent panel at the points where
blending would begin and end in order to document and acknowledge the need
for primer or color to be applied onto the next adjacent panel.
- Take a picture for the repair file at this point and again before masking tape and paper is removed to validate the blend was performed as written according to the initial estimate.
Part #: 3M.538904
Price and Units
Units: EACH
Units: EACH |